
84 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001
7. Using the test command and the device path found in Step 6, start the adapter’s
FCode self-test.
Refer to the OpenBoot Command Reference Manual for more information on the test
command.
If all of the tests pass, you will see these messages:
If the adapter fails a test, you will see an error message (in this example, the Register
test failed):
Note – If the test command fails, verify that the adapter hardware is installed
correctly. If necessary, replace the adapter or contact your service provider for
support.
8. After testing the adapter, type the following commands to return the OpenBoot
PROM to the standard operating mode.
ok test device path
ok test /pci@if,0/pci@1/pci@1/pci@a/SUNW,ma@0
Register Test -- succeeded.
Memory Test -- succeeded.
SAHI Internal Loopback Test -- succeeded.
SUNI Internal Loopback Test -- succeeded.
ok
ok test /pci@if,0/pci@1/pci@1/pci@a/SUNW,ma@0
Register Test -- failed.
Memory Test -- succeeded.
SAHI Internal Loopback Test -- succeeded.
SUNI Internal Loopback Test -- succeeded.
ok
ok setenv diag-switch? false
ok setenv auto-boot? true
Kommentare zu diesen Handbüchern