Sun-microsystems 3U Bedienungsanleitung PDF herunterladen (Seite 105)

Appendix B Testing the Adapter 83

▼ To Run the FCode Self-Test Diagnostic

For more information about the OpenBoot commands (including test) in this

section, refer to the OpenBoot Command Reference manual.

1. Before shutting down the operating environment and halting the system, ensure

that all significant application activity on the server has acquiesced.

2. Follow the appropriate procedures, as documented in the system’s service manual,

to shut down and halt the system.

Refer to the system’s documentation for the complete shutdown procedure.

After shutting down the system, you should now see the OpenBoot PROM ok

prompt on the system console.

3. At the ok prompt, set the auto-boot? configuration variable to false.

4. Set the diag-switch? parameter to true in order to see the diagnostic power-on self-

test (POST) messages.

5. Reset the system to activate these parameter changes.

6. Use the show-devs command to display the list of devices.

Among the list of devices, you should see the SUNW,ma device specific to the

SunATM adapter, as shown in the following example.

Note – The device path shown above is an example. The actual device path

displayed on your system may be different.

ok setenv auto-boot? false

ok setenv diag-switch? true

ok reset-all

ok show-devs

. . .

/pci@if,0/pci@1/pci@1/pci@a/SUNW,ma@0

. . .

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 141 142

Keine Kommentare

Sun-microsystems 3U Bedienungsanleitung Seite 105