Sun-microsystems 2.0 Bedienungsanleitung PDF herunterladen (Seite 23)

InstallingSunFastEthernetAdapter 2.1 SoftwareOnSolaris2.xSystems 3-3

3.2 Net-InstallofSolaris2.4Overthehme Interface

This section is only applicable if you are installing Solaris 2.4 on a net-install

client system over the SunFastEthernet Adapter (hme) interface.

Note – The Solaris 2.4 CD-ROM cannot be used to perform a net-install (read

only), thus the Solaris 2.4 CD image archive is required to update certain

SunFastEthernet Adapter files.

UpdatingtheSolaris2.4Archive toUsethehme Interface

1. Determine the directory where the CD image is located on the boot server.

For example, if the Solaris software is located within a directory named

DIR, change to the root partition of the client being installed by typing:

The /etc/bootparams file will point you to the client’s root partition.

2. Edit the name_to_major file by adding an entry for the SunFastEthernet

Adapter device (hme).

If the major device number for the last file entry is n then use n+1 for the

hme channel major device number. As shown in the example below, if the

last entry for the major device number is 108, use 109 for the hme device.

3. Copy the hme driver from the SunFastEthernet Adapter 2.1 CD-ROM to

the client’s root partition as follows:

4. On the client system, perform the tasks in Section 3.5.3, “Booting From

the Network Using Solaris 2.4.”

# cd DIR/export/exec/kvm/<archive_of_arch>/etc

# llcl 107

# audiocs 108

# hme 109

# cp /cdrom/sunfast_2_1/2.4/SUNWhmdl/reloc/kernel/drv/hme \

DIR/export/exec/kvm/<archive_of_arch>/kernel/drv

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Keine Kommentare

Sun-microsystems 2.0 Bedienungsanleitung Seite 23