Sun-microsystems 2.0 Bedienungsanleitung PDF herunterladen (Seite 18)

2-2 SunFastEthernetAdapter2.0 Installation and User’sGuide—July 1996

2.2 VerifyingtheInstallation

After the SunFastEthernet Adapter is installed, and before booting the system,

verify installation by performing the following tasks. Refer to the Solaris 2.x

Handbook for SMCC Peripherals manual or your Solaris documentation for the

detailed instructions.

1. Power on the system, and when the banner appears, press the Stop-A keys

to interrupt the boot process and to get to the ok prompt.

2. Use the show-devs command to list the system devices.

You should see a line (similar to the one in the example below) in the

display, specific to the SunFastEthernet Adapter:

• SUNW,hme@0 identifies the adapter’s Ethernet device.

Note – In the above example, the number 0 following hme@ corresponds to the

SBus slot in which the SunFastEthernet Adapter resides.

If you do not see the device listed, check that the adapter is properly seated

and reinstall the adapter, if necessary.

DiagnosticsTesting

• For SunFastEthernet Adapter diagnostics testing on systems running Solaris

2.3 and 2.4, see Appendix A, “Running Diagnostics for Solaris 2.3 and 2.4.”

• For SunFastEthernet Adapter diagnostics testing on systems running Solaris

2.5 and SunOS versions 4.1.3_U1 and 4.1.4, refer to the SunVTS 2.0 User’s

Guide (part number: 802-5331).

ok show-devs

...

/iommu@f,e0000000/sbus@f,e0000000/SUNW,hme@0,8c00000

...

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Keine Kommentare

Sun-microsystems 2.0 Bedienungsanleitung Seite 18