Sun Microsystems CP3220 Bedienungsanleitung Seite 65

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 135
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 64
Chapter 2 Hardware Installation and Service 2-31
To reset the jumper and return the CMOS settings to the default settings, perform
the following steps:
1. Remove the jumper housing from the run position (P1/P2) and move it to the
reset position (P2/P3).
FIGURE 2-11 Jumper 1 in the Reset Position
2. Wait at least one second for the CMOS settings to reset and then move the
jumper housing back to the run position.
3. Reinstall the blade server.
Use the procedure in Section 2.2.3.2, “Installing the Blade Server Into the Shelf”
on page 2-12.
Note The blade server will operate normally only when the jumper housing is in
the run position.
Jumper 1
Pin 1
Pin 2
Pin 3
Zone 3
AMC slot B1
Zone 3
connectors
Seitenansicht 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 134 135

Kommentare zu diesen Handbüchern

Keine Kommentare