Sun-microsystems Ethernet MMF/UTP Adapter Bedienungsanleitung Seite 51
- Seite / 122
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 2 Installing the Adapter 17
The phy-type value is assigned as follows:
Note – If you are going to set the local-mac-address property, note the
local-mac-address of your device at this time. See “Setting the local-mac-
address Property” on page 17 for more information.
Setting the local-mac-address Property
Note – Setting the local-mac-address property is required only if you will be
booting from the network.
The network interface of the Sun PCI-Express Dual Gigabit Ethernet adapter has
been assigned a unique media access control (MAC) address that represents the 48-
bit Ethernet address for that interface. The OpenBoot firmware reports this MAC
address by means of the local-mac-address property in the device nodes
corresponding to the network interface.
A system does not always use this assigned MAC address if it has a system-wide
MAC address. In such cases, the system-wide MAC address applies to all network
interfaces on the system.
The device driver, or any other adapter utility, can use the network device’s MAC
address (local-mac-address) while configuring it. In the Solaris Operating
System, you can use the MAC address when booting over the network.
The mac-address property of the network device specifies the network address
(system-wide or local-mac-address) used for booting the system. To start using
the MAC address assigned to the network interface of the Sun PCI-Express Dual
Gigabit Ethernet adapter, set the NVRAM configuration variable
local-mac-address? to true.
Media type phy-type
Fiber pcs
Copper mif
ok setenv local-mac-address? true
- PCI-Express Dual Gigabit 1
- Ethernet MMF/UTP Adapter 1
- Installation and User’s Guide 1
- Contents 3
- Index 87 7
- FCC Class B Notice 9
- FCC Class A Notice 9
- BSMI Class A Notice 11
- CCC Class A Notice 11
- GOST-R Certification Mark 12
- Safety Agency Compliance 13
- Statement 13
- Battery Warning 14
- System Unit Cover 14
- Rack System Warning 14
- Laser Compliance Notice 15
- CD and DVD Devices 15
- Mesures de sécurité 15
- Symboles 16
- Modification du matériel 16
- Conformité SELV 16
- Couvercle de l'unité 17
- Vorschriften 18
- Aufstellung von Sun-Geräten 19
- SELV-Konformität 19
- Anschluss des Netzkabels 19
- Warnung bezüglich Batterien 19
- Normativas de seguridad 20
- Class 1 Laser Product 23
- Luokan 1 Laserlaite 23
- Klasse 1 Laser Apparat 23
- Laser Klasse 1 23
- Declaration of Conformity 25
- Using UNIX Commands 30
- Typographic Conventions 31
- Shell Prompts 31
- Related Documentation 32
- Third-Party Web Sites 32
- Sun Welcomes Your Comments 33
- Sun PCI-Express Dual Gigabit 35
- Ethernet Adapter Overview 35
- Low-Profile Adapter 36
- ExpressModule Adapter 39
- ATNSW Attention Switch is a 41
- Patches and Updates 43
- Installing the Adapter 47
- To Verify the Installation 48
- Fiber pcs 51
- Copper mif 51
- Rebooting the System 52
- Power Off 52
- Hot-Plug 52
- Configuring ipge and e1000 55
- Driver Parameters 55
- ■ 100 Mbit/sec, half-duplex 56
- ■ 10 Mbit/sec, full-duplex 56
- ■ 10 Mbit/sec, half-duplex 56
- ■ Using the ndd utility 56
- ■ Using the ipge.conf file 56
- ■ Noninteractive 57
- ■ Interactive 57
- TABLE 3-4 through TABLE 3-1) 58
- % man prtconf 60
- ■ In this example: 61
- Link Partner Parameters 62
- To Discover Link Settings 64
- Checking Configurations 64
- # kstat ipge:0 65
- Driver Operating Statistics 66
- Parameter Description 67
- Device Driver Parameters 68
- Parameter Status Description 69
- Operational Mode Parameters 70
- Flow Control Parameters 71
- Interpacket Gap Parameters 72
- Interrupt Parameters 74
- Jumbo Frames 74
- Configuring e1000g Driver 77
- Parameters 77
- 1 10 Mpbs half-duplex 81
- 2 10Mpbs full-duplex 81
- 3 100Mpbs half-duplex 81
- 4 100Mpbs full-duplex 81
- Type the kstat command: 82
- 1500 but not 9000 90
- Configuring VLANs 91
- To Configure Static VLANs 94
- Operating range Up 100 meters 98
- Gigabit Ethernet UTP adapter 99
- ExpressModule Performance 100
- Specifications 100
- ExpressModule Environmental 101
- Requirements 101
- Specification Measurement 102
- Diagnostic Software 103
- SunVTS Documentation 104
- Using the SunVTS netlbtest 105
- ■ 10 Mbps PHY loopback 108
- Linux Platforms 111
- # depmod 112
- # modprobe e1000 112
- Low-Profile adapter 115
- Environment 116
- Keyword Description 118
- Interfaces 120
Verwandte Produkte und Handbücher für Hardware Sun-microsystems Ethernet MMF/UTP Adapter
(48 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern